iPhone 12 Screen Replacement Repair Guide

iPhone 12 Screen Replacement- TYPhonepart Repair Guide

MaHowardFeb 27, '21

iPhone 12 Screen Replacement

Tools/Materials

Step 1: Remove the Apple 12 Screen display

  1. Turn off the iPhone, loosen and loosen the two pentagonal screws at the bottom.
    Turn off the iPhone, loosen and loosen the two pentagonal screws at the bottom
  2. Pull out the screen with a suction cup, cut the screen into pieces with a plastic pressure plateand separate them.
    Pull out the screen with a suction cup, cut the screen into pieces with a plastic pressure plate, and separate them.
  3. Pry the screen and turn it to one side, loosen the 6 Y-shaped screws, and remove the metal shield to fix the flexible cable.
    Pry the screen and turn it to one side, loosen the 6 Y-shaped screws, and remove the metal shield to fix the flexible cable
  4. Unplug the battery cableand then the display screen bends the cable.
    Unplug the battery cable, and then the display screen bends the cable
  5. Loosen the four screwsremove the metal panel, fix the flexible cable of the ear speaker, and disconnect the cable to completely separate the screen.
    Loosen the four screws, remove the metal panel, fix the flexible cable of the ear speaker, and disconnect the cable to completely separate the screen
     

Step 2: Replace the Apple 12 display

  1. Remove the two Phillips screws and two Y screwsfix the earbud speakerdisconnect the flexible cable, and carefully remove the ear speaker from the screen.
    Remove the two Phillips screws and two Y screws, fix the earbud speaker, disconnect the flexible cable, and carefully remove the ear speaker from the screen
  2. Take out a new Apple 12 screen, install the headset on the screen, connect the flexible cable to the screen, and fix the cable on the metal panel with screws.
    Take out a new Apple 12 screen, install the headset on the screen, connect the flexible cable to the screen, and fix the cable on the metal panel with screws
  3. Connect the newly replaced flexible screen cable to the phone.
    Connect the newly replaced flexible screen cable to the phone

Step 3: Test the new screen function and assemble the iPhone

  1. Connect the battery flexible cable, turn on the mobile phone, and test the function of the new screen.
    Connect the battery flexible cable, turn on the mobile phone, and test the function of the new screen
  2. After confirming that all functions are normal, turn off the iPhone. Disconnect the battery flexible cable and the screen flexible cable, and separate the screen again.
    After confirming that all functions are normal, turn off the iPhone. Disconnect the battery flexible cable and the screen flexible cable, and separate the screen again
  3. Use tweezers to remove the remaining stickers on the rear housing frame. Apply for a new Apple 12/12 Pro frame sticker and put it on the frame.
    Use tweezers to remove the remaining stickers on the rear housing frame. Apply for a new Apple 12/12 Pro frame sticker and put it on the frame
  4. Connect the screen flexible cable and the battery connector, and fix the connector cable with a small metal shield and screws.
    Connect the screen flexible cable and the battery connector, and fix the connector cable with a small metal shield and screws
  • Assemble the display screen backwards and press it lightly to ensure that it is tightly assembled. Tighten the two pentagonal screws backwards. The whole process is complete.
    Assemble the display screen backwards and press it lightly to ensure that it is tightly assembled. Tighten the two pentagonal screws backwards. The whole process is complete
    NOTE:
  • During the installation process, do not press it forcefully, which may cause damage to the inner LCD
  • If your iPhone has a cracked screen, keep further breakage contained and prevent bodily harm during your repair by taping over the glass.

laissez un commentaire

Veuillez noter que les commentaires doivent être approuvés avant d'être publiés.